Key points are not available for this paper at this time.
Plastic recycling is a key aspect to achieve effective polymer circularity, especially for polyolefins for which usually the mechanical recycling is considered a downcycling process. This downcycling phenomenon arises from the progressive deterioration of the polymer microstructure during reprocessing, resulting in a gradual loss of processability and properties, ultimately compromising the possibility of using recycled polyolefins for applications with high engineering requirements. In this work, the effects of the thermomechanical degradation on the microstructure of polypropylene (PP) were assessed by subjecting the polymer to multiple extrusion cycles. The objective is investigating the evolution of the molecular weight and of the macromolecular architecture of PP typically occurring in a mechanical recycling process. Furthermore, a commercially available additive capable to restoring the PP molecular weight was introduced, with the purpose of proposing an effective upcycling strategy for achieving recycled PP with enhanced processability. In particular, the effects of the additive were evaluated following two different strategies that simulate pre-consumer or post-consumer mechanical recycling. The obtained results indicated that the introduction of the additive can effectively prevent the decrease of the molecular weight of reprocessed PP, also inducing some melt structuring phenomena associable with the introduction of some long chain branching and/or crosslinking. Finally, it was demonstrated that different macromolecular architectures for recycled PP can be achieved depending on the residence time during the processing in presence of the additive, opening new perspectives towards the possibility of obtaining recycled PP with modulable flow characteristics and, hence, processability.
Bernagozzi et al. (Tue,) studied this question.