Key points are not available for this paper at this time.
Abstract Large‐scale implementation of electrochemical CO 2 conversion to value‐added products is currently hampered by high electrolyzer cell voltages, resulting in low energy efficiency and high operating costs. Cell voltages are typically well above 3 V and need to be significantly lowered whilst maintaining current densities greater than 200 mA cm −2 to enable energy‐efficient CO 2 electroreduction. This can be addressed through modification of the resistive components of the device to reduce energy consumption and lower operating costs. Electrodes, electrolyte solutions, and the separator between compartments, provide the largest contributions to the overall cell voltage, therefore decreasing their resistance can lower the electricity input required to drive effective CO 2 conversion. Here, by careful analysis and tuning of the various sources of voltage drops within the cell, an optimized diaphragm‐based CO 2 R device is presented, which is able to operate at an industrially relevant current density of 200 mA cm −2 with an |E cell | as low as 2.89 V, amongst the lowest reported values to date.
Perazio et al. (Wed,) studied this question.