Key points are not available for this paper at this time.
The present investigation studies the impact of post-weld heat treatment (PWHT) on the microstructure and mechanical characteristics of joints made by gas tungsten arc welding between duplex stainless steel and super-duplex stainless steel specimens. The PWHT process was considered at 1100 °C for 10 minutes followed by water quenching on UNS S32304 and UNS S32750 materials. Scanning electron microscopy, optical microscopy, X-ray diffractometry (XRD), and energy dispersive X-ray analyses have been applied in microstructure evolution, including recognizing local chemical contents and elemental distribution. To analyze the mechanical characteristics of samples, tensile and hardness tests were performed. It was shown that after applying PWHT, the morphology of the austenite varied becoming mostly intergranular/spheroidal in shape, accompanied by an improvement in the percentages of austenite. This investigation indicates the PWHT results in restoring an equal percentage of both phases. The phase percentages, based on both ASTM E1245 and ASTM E562, show a good agreement between the austenite and ferrite phases of weld materials. According to XRD, the phases are mainly ferrite and austenite with different lattice parameters with no evidence of unwanted intermetallic phases. It was concluded that the PWHT process plays a crucial role in the ductility of joint specimens due to the phase balance between austenite and ferrite.
Tahaei et al. (Mon,) studied this question.