Fluid‐Induced Aseismic Slip May Explain the Non‐Self‐Similar Source Scaling of the Induced Earthquake Sequence Near the Dallas‐Fort Worth Airport, Texas

Abstract Numerous studies have reported the occurrence of aseismic slip or slow slip events along faults induced by fluid injection. However, the underlying physical mechanism and its impact on induced seismicity remain unclear. In this study, we develop a numerical model that incorporates fluid injection on a fault governed by rate‐and‐state friction to simulate the coupled processes of pore‐pressure diffusion, aseismic slip, and dynamic rupture. We establish a field‐scale model to emulate the source characteristics of induced seismicity near the Dallas‐Fort Worth Airport (DFWA), Texas, where events with lower‐stress drops have been observed. Our numerical calculations reveal that the diffusion of fluid pressure modifies fault criticality and induces aseismic slip with lower stress drop values (<1 MPa), which further influence the timing and source properties of subsequent seismic ruptures. We observe that the level of pore‐pressure perturbation exhibits a positive correlation with aseismic‐stress drops but a reversed trend with seismic‐stress drops. Simulations encompassing diverse injection operations and fault frictional parameters generate a wide spectrum of slip modes, with the scaling relationship of moment ( M 0 ) with ruptured radius ( r 0 ) following an unusual trend, , similar to observed in the DFWA sequence. Based on the consistent scaling, we hypothesize that the lower‐stress‐drop events in the DFWA may imply less dynamic ruptures in the transition from aseismic to seismic slip, located in the middle of the broad slip spectrum, as illustrated in our simulations.