Key points are not available for this paper at this time.
A CFD simulation of the condensation flow of R600a and R290 within microchannels was conducted to explore the effect of mass flux, hydraulic diameter, and vapour quality on heat transfer rate and pressure drop. Data obtained from CFD simulations were used to develop new heat transfer and pressure drop correlations for the condensation flows of R600a and R290, which are climate-friendly refrigerants. Steady-state numerical simulations of condensation flow of refrigerants were carried out inside a single circular microchannel with diameters varying between 0.2 and 0.6 mm. The volume of fluid approach was used in the proposed model, calculating the interface phase change using the Lee model. The CFD simulation model was validated via a comparison of the simulation results with the experimental data available in the literature. It is found that the newly developed Nu number correlation shows a deviation, with an Ave-MAE of 11.16%, compared to those obtained by CFD simulation. Similarly, the deviation between friction factors obtained by the newly proposed correlation and those obtained by CFD simulation is 20.81% Ave-MAE. Widely recognized correlations that are applicable to the condensation of refrigerants within small-scale channels were also evaluated by comparing newly developed correlations. It is concluded that the newly proposed correlation has a higher accuracy in predicting the heat transfer coefficient and pressure drop. This situation can contribute to the creation of a sustainable system via the use of microchannels and climate-friendly refrigerants, like R600a and R290.
Başaran et al. (Fri,) studied this question.