Key points are not available for this paper at this time.
Objective. This research study investigated the effect of new decontamination protocols on the bonding capacity of saliva-contaminated monolithic zirconia (MZ) ceramics cemented with two different monomer-containing self-adhesive resin cements. Materials and Methods. Standardized tooth preparations (4 mm. axial height) were performed for eighty human maxillary premolars under constant water cooling system. Eighty monolithic zirconia crowns (Whitepeaks Supreme Monolith) ( n=8/10 groups) were manufactured by CAD-CAM. Specimens were kept in the artificial saliva at pH=7.3 for 1 minute at 37°C except control groups. The specimens have not been prealumina blasted and grouped according to cleaning methods and resin cements: control groups (C) (no saliva contamination+GPDM+4‐META (N) (CN) and 10-MDP (M) containing resin cement (CM), alumina blasted AL+GPDM+4‐META (ALN) and 10-MDP containing resin cement (ALM), zirconium oxide containing universal cleaning agent (IC) applied+GPDM+4‐META (N) (ICN) and 10-MDP containing resin cement (ICM), pumice (P) applied+GPDM+4‐META (PN) and 10-MDP containing resin cement (PM), and air-water spray (AW) applied+GPDM+4‐META (AWN) and 10-MDP containing resin cement (AWM)). Monobond Plus was applied to all surfaces for 40 seconds before cementation. The thermal cycle was applied at 5,000 cycles after cementation. The crowns were tested in tensile mode at a speed of 1 mm/min. The mode of failure was recorded. SEM examinations were carried out at different magnifications. Data were analyzed using rank-based Kruskal-Wallis and Mann–Whitney tests. Results. No significant differences were found between the surface treatments and between the two types of resin cements. Interaction effects between surface treatments and resin cements were found to be significant by two-way ANOVA analysis. ICM group resulted in significantly better bond strength results compared with CN. ICM was found to result in better bond strength results compared with PM. The combination of universal cleaning agent and 10-MDP containing resin cement had significantly the highest cementation bond strength values. The increasing order of mean tensile bond strength values of decontamination protocols was CAWPALIC . The mean tensile bond strength of 10-MDP containing resin cement was slightly higher than GPDM+4‐META containing resin cement. Conclusions. Universal cleaning agents can be preferred as an efficient cleaning method with 10-MDP-containing cement after saliva contamination for better adhesive bond strength of 4 mm crown preparation height of monolithic zirconia ceramics.
Demir et al. (Thu,) studied this question.