Investigation of regeneration cycles with different catalysts on steam gasification of biomass

In this work, agricultural biomass waste was gasified in a two-zone tubular reactor in the presence of steam. Firstly, during preliminary experiments the effect of temperature in the 1st and 2nd reactor zone, as well as the influence of catalysts and steam/raw material ratio was investigated, then the reusability of catalysts was also studied during ten regeneration cycles. Based on the preliminary results, in the 1st reactor zone a lower temperature was used (400°C), where the yield of carbon dioxide was ∼55%, which has a positive effect on numerous reactions, also it can be converted to carbon monoxide with proper catalysts with in-situ process. Regarding the temperature, it is important to be mentioned that a significant difference was observed in the yield of synthesis gas at 700°C thus, the experiments were carried out using 700°C in the 2nd reactor zone. A natural (Clinoptilolite) and a synthetic zeolite (ZSM-5), a mesoporous alumina (Al2O3) and a carbon dioxide capturing carrier (CaO) were selected and impregnated with nickel for further use and for enhancing the yield of synthesis gas and hydrogen during the gasification process. The utilization of catalysts helped the in-situ reduction of carbon dioxide while their performance in the gasification process during the regeneration cycles was also investigated. Henceforward, the tested Ni/ZSM-5, Ni/Al2O3 and Ni/Clinoptilolite, reduced the amount of carbon monoxide from the 5th regeneration cycles, while the amount carbon dioxide with the four mentioned catalysts was decreased by 15-35 mmol/g raw material, compared to the results obtained during thermal degradation.