Mechanical, morphological and wear resistance of natural fiber / glass fiber-based polymer composites

Natural fibers along with glass fibers were used as the reinforcement of an epoxy matrix for the betterment of mechanical and wear applications. The combination of overall wt% up to 20 resulted in 23.8 MPa of tensile strength compared to 15.5 MPa for untreated fibers. The wt% of areca fiber (AF) (20 wt%)/glass fibers (GF) (20 wt%) with 5% alkali treatment yielded a maximum tensile strength up to 62.6% in comparison to untreated fiber at lowest percentage of 10 wt%. The increase in flexural strength with alkali treatment was observed from 20 to 50 wt% hybrid fiber incorporation. The alkali treated fibers, untreated fiber combinations achieved 33.8% and 26.8% improvement with impact properties. A decrease in the wear loss was shown with the increase in wt% of hybrid fiber incorporation from 20 to 40 wt%. The interfacial adhesion of fiber with matrix created a pressure absorbing zone that was positively influenced with applying higher loads. The frictional rate was highly increasing with increase in hybrid fiber wt% and also with higher loads applied. The SEM results for treated 20 wt% AF+20 wt% GF with hybrid fiber incorporation observed better results due to improved adhesion of fiber with matrix phase.