Effects of liquid water injection on flame surface topology and propagation characteristics in spray flames: A direct numerical simulation analysis

The effects of water injection on flame surface topology and local flame propagation characteristics have been analyzed for statistically planar turbulent n-heptane spray flames with an overall (i.e., liquid + gaseous) equivalence ratio of unity using carrier-phase direct numerical simulations. Most fuel droplets have been found to evaporate as they approach the flame even though some droplets can survive until the burnt gas side is reached, whereas water droplets do not significantly evaporate ahead of the flame and the evaporation of water droplets starts to take place in the reaction zone and is completed within the burnt gas. However, the gaseous-phase combustion occurs predominantly in fuel–lean mode although the overall equivalence ratio remains equal to unity. The water injection has been found to suppress the fuel droplet-induced flame wrinkling of the progress variable isosurface under the laminar condition, and this effect is particularly strong for small water droplets. However, turbulence-induced flame wrinkling masks these effects, and thus, water injection does not have any significant impact on flame wrinkling for the turbulent cases considered here. The higher rate of evaporation and the associated high latent heat extraction for smaller water droplets induce stronger cooling effects, which weakens the effects of chemical reaction. This is reflected in the decrease in the mean values of density-weighted displacement speed with decreasing water droplet diameter. The weakening of flame wrinkling as a result of injection of small water droplets is explained through the curvature dependence of the density-weighted displacement speed. The combined influence of cooling induced by the latent heat extraction of water droplets and flame surface flattening leads to a decrease in volume-integrated burning rate with decreasing water droplet diameter in the laminar cases, whereas the cooling effects are primarily responsible for the drop in burning rate with decreasing water droplet diameter in the turbulent cases.