Key points are not available for this paper at this time.
The supracondylar fracture of the child is a common fracture. Its physiology, physiopathology and treatment use periosteum. As far as we know, there is no 3D printed model of this typical fracture in children with periosteum. The purposes of the research are to present the concept of an educational 3D printed supra condylar model with periosteum of the child and its expert validation.Materials and MethodsThe basis for the paediatric elbow model was a 3D scan of a four-year-old girl. Once the data had been extracted, the models were constructed using 3D Slicer®, Autodesk fusion 360® and Ultimaker Cura® software's. The Creality 3D Ender 6 SE Printer® used PLA filaments to print bone and TPU for periosteum. Printing took place at the University Hospital and the steps were modelled by hand. 3D printed bones and 3D printed periosteum were manually assembled.ParticipantsExpert validation with twelve paediatric orthopaedic surgeons took place in three University hospitals of the North of France.ResultsFour Lagrange and Rigault 3D printed models of supracondylar fractures with periosteum were obtained with 200 hours of design, printing and manual assembly based on a four-year-old elbow. According to the paediatric orthopaedic surgery experts, the size of the model is very good, but the model itself is of little interest compared to the information provided by the reconstruction of a 3D scanner. In total, with 9 out of 12 questions scoring higher than 8/10, the model was considered to be a good model for informing parents and teaching students.ConclusionsThis study details the design of the first 3D-printed supra condylar fracture model in children with a full-size physeal and periosteum. The model has been validated by paediatric orthopaedic surgery experts.
Lubet et al. (Wed,) studied this question.