Electrical properties of different materials studied by sub-microsecond underwater electrical explosions of single wires

Results of an experimental research and one-dimensional hydrodynamical simulations of critically damped sub-microsecond timescale underwater electrical explosions of wires made of 12 different materials are presented. Using current and voltage waveforms, streak shadow images of the shocks generated in water and wire expansion obtained by one-dimensional hydrodynamic simulations, the maximal values of the energy density, energy density deposition rates, and specific action integrals were determined. It is shown that for all study materials, the deposited energy density significantly exceeds the energy density required for the solid–liquid phase transition but is substantially smaller to induce a full liquid–vapor phase transition of the wire. At the time when the maximal value of the deposited power is realized, the deposited energy densities were found to be larger than the atomization energy for all materials. Estimates of the plasma parameters show that the explosion of the wires can be characterized by a high resistance and lowly ionized weakly coupled plasma. Three groups of materials were distinguished by either decrease, plateau, or increase in the resistance after the maximum of the deposited power. It was confirmed that the observed maximum Planckian temperature for all wire material does not exceed 6000 K due to the “bath” effect and that there is a correlation between the wire radial expansion and the strong shock wave velocities.