Key points are not available for this paper at this time.
Precipitation strengthening is a crucial method for enhancing the mechanical properties of steel. The bridgman directional solidification furnace, optical microscope (OM), scanning electron microscope (SEM), electron probe analyzer (EPMA) and transmission electron microscope (TEM) were used to investigate the effect of solidification cooling rate on the solidification microstructure, microsegregation, and nanoprecipitates in medium carbon CrMo cast steel. The results indicate that as the cooling rate increases, the solidification microstructure is significantly refined. The relationship between the cooling rate (CA) and primary dendrite arm spacing (PDAS, λ1) and secondary dendrite arm spacing (SDAS, λ2) are given by λ1 = 123.74 × C-0.4088A, λ2 = 66.63 × C-0.6532 A. Solute elements like Cr, Mo, and V exhibit noticeable positive segregation in the inter-dendritic. When the cooling rate does not exceed 0.47 °C/s, the solute concentrations in the inter-dendritic increase with higher cooling rate, leading to a decrease in the effective solute partition coefficient. This phenomenon is primarily attributed to the back diffusion of solute elements during solidification. Following heat treatment, precipitation of M6C, V(C,N), and M23C6 occurs within the inter-dendritic regions. If the solidification cooling rate does not exceed 0.47 °C/s, the density and volume fraction of nanoprecipitates increase with higher cooling rate. This trend primarily results from the reduction in critical nucleation radius and critical nucleation energy, facilitating easier nucleation of nanoprecipitates.
Zhao et al. (Mon,) studied this question.