Key points are not available for this paper at this time.
Wood is known for its complex hygroscopic properties. Previous studies show that both the temperature-dependency and the hysteresis in sorption should be included in the physical models, if the most accurate results are desired from simulations of building assemblies with wood-based materials. Literature is scarce on the topic, where the significance of these aspects on the reliability of mould-risk assessments is inspected. Exterior walls with glass wool insulation and LDF-sheathing were studied by using two different models with previously measured material data. Over 300 hygrothermal simulations were carried out, where mould-indices were computed on the warm side of the sheathing. According to both conventional and more sophisticated model, the studied walls perform well in cold climate if no driving rain leaks in. Temperature-dependent and hysteretic model yields slightly smaller mould-indices in general, but for certain leaky cases the difference is significant, which indicates the importance of sophisticated sorption-properties in modelling.
Huttunen et al. (Sat,) studied this question.