Key points are not available for this paper at this time.
• Fracture tests focusing on the bonding layer of laminated pultruded CFRP plates. • Effect of mode mix ratios on crack growth and failure pattern of fracture surface. • Mixed mode I/II failure criteria for predicting crack initiation toughness. • Applicability of existing testing standards on laminated pultruded CFRP plates. • Detrimental or beneficial effects of manufacturing defects on fracture behaviours. Laminated pultruded composite plates are gaining interest for use in wind turbine blades due to their excellent structural performance with affordable cost. However, there is limited understanding of their fracture properties. The present work explores the interlaminar fracture behaviour of pultruded composite plates, bonded through resin infusion, to form thick CFRP structures. Mode-I, −II, and mixed-mode (I/II) tests were performed to obtain fracture properties at different mixed-mode ratios. Mode I crack propagation exhibits stick–slip behaviour, resulting in brittle failure in a few steps, while mode II provides more stable crack propagation along with cohesive failure. The mixed-mode fracture patterns follow the trend of the mode-mix ratios, in which higher mode-mix ratios (more mode II) induce more stable crack propagation. Benzeggagh-Kenane and power law criteria were compared regarding their prediction of crack initiation toughness given a mode mix ratio, and a linear relation between the mixed-mode I/II fracture toughness components could exist at interfaces of laminated pultruded plates. Meanwhile, applicability of testing standards and the effect of manufacturing-induced defects on fracture properties are thoroughly discussed. The results show that existing standards provide sufficient support for characterising fracture properties of bonded pultruded plates; and that manufacturing-induced defects can be detrimental to crack propagation and cause more brittle behaviour in mode I dominant cases, while beneficial effect of defects by toughening the interface was exhibited in mode II dominant cases.
Li et al. (Wed,) studied this question.