Guldborgsund Arson House Fire Experiment and Numerical Investigation

Abstract This paper describes the Guldborgsund arson house fire experiment performed in Denmark and the subsequent numerical investigation. Gas temperatures were measured with four thermocouple trees, and smoke detector activation times were recorded in all rooms. A two-step approach was used to perform the numerical modelling for reproduction of the fire scene. The measured temperatures in the room of fire origin were used as an input for back calculating the Heat Release Rate (HRR) with the two-zone model Argos. As a next step, this HRR was used in the Fire Dynamic Simulator (FDS) to predict the temperatures and the smoke detectors’ activation times in other rooms. The FDS model was partly build using output files from the laser scanning. A sensitivity analysis is presented, where the effect of nine input parameters was investigated, including HRR, the material properties, the height of the fuel bed, the fire area, level of geometrical detail of the first item ignited etc. This study showed that the measured soot deposition heights on the walls differed from the heights of measured sharp temperature gradients used to indicate the hot smoke layer. The numerical simulations resulted in less than 50% error for most of the temperature measurement points during the fuel-controlled stage of the fire and results were the most sensitive to the input HRR. Material properties in FDS had a significant influence on the computed upper-layer gas temperatures at late stages of the fire.