Key points are not available for this paper at this time.
The phenomenon of lithic miniaturization during the Late Pleistocene at times coincided with increased artifact standardization and cutting edge efficiency–likely reflecting the use of small, sharp artifacts as interchangeable inserts for composite cutting tools and hunting weapons. During Marine Isotope Stage 2, Upper Paleolithic toolmakers in northern East Asia specifically used pressure techniques to make small, highly standardized lithic artifacts called microblades. However, little is currently known about how microblades affected the cutting edge efficiency of the toolkits they were a part of. We applied three methods of analyzing cutting edge efficiency to two Upper Paleolithic assemblages recently excavated from Tolbor-17, Mongolia, that document the periods before and after the introduction of microblade technology to the Tolbor Valley. A model incorporating allometric relationships between blank cutting edge length and mass suggests no difference in efficiency between the two periods, while two more conventional approaches both indicate a significant increase. The potential for improved cutting edge efficiency is only observed when the microblade sample is artificially inflated via simulation. Our results highlight challenges related to detecting and interpreting archaeological differences in cutting edge efficiency at the assemblage level.
Johnson et al. (Fri,) studied this question.