Key points are not available for this paper at this time.
Abstract Background The purpose of this in vitro study was to compare and evaluate the stress distribution of maxillary first premolar residual crowns restored with post-core crowns, endocrowns and inlay crowns after deep margin elevation, to explore the fitting restoration for residual crowns using finite element analysis. Methods A healthy complete right maxillary first premolar from a male adult was scanned by cone beam computed tomography (CBCT). The finite element model of the tooth was established by reverse engineering software such as Mimics, Geomagic and Hypermesh. On this basis, the residual crown model after deep margin elevation was made, and the experimental group models were divided into three groups, those restored with post core crowns, endocrowns and inlay crowns. Vertical and oblique static loads were applied to the experimental models to simulate the force on the tooth during mastication (the loading position was located in the central fossa of the occipital surface, and the load was 100 N) using Abaqus software. Results The peak value and distribution of von Mises stress in each part of the experimental model were observed. After deep margin elevation, the peak dentin von Mises stresses were lower than the tensile strength of normal dentin in the post-core crown, endocrown, and inlay crown groups; the lowest stress results were found in the post-core crown group for the dentin, restoration, enamel, and deep margin elevation (DME) layers under vertical and oblique loading. In terms of stress distribution clouds, the peak stresses in the dentin tissue were located in the apical 1/3 of the root after postcore crown restorations for both loads, while stress concentrations were evident in the cervical and root areas after endocrown and inlay crown restorations; regardless of the load and restoration method, the corresponding stress concentration areas appeared at the junction of the DME and dentin tissue at the loading site of the restorations; Conclusions Post-core crowns, endocrowns and inlay crowns can be used to restore residual crowns after deep margin elevation, and post-core crowns can better protect the residual tooth tissue.
Wu et al. (Fri,) studied this question.