Key points are not available for this paper at this time.
The current investigation focuses on improving the performance of a single slope solar still integrated with Phase Change Material as energy storage media. The problem of low thermal conductivity of PCM which hinders the energy storage capability has been addressed by incorporating fins with different profiles into the energy storage unit. Initially, an experimental investigation was conducted and analyzed to assess the effective performance of a Conventional Single Slope Solar Still (CSS) using various water depth levels: 1–4 cm. The optimal basin water depth for testing solar still with energy storage material along with fins was identified as 2 cm. Subsequently, the CSS was subjected to performance enhancement investigation under three different conditions: Case 1 – Solar Still (SS) with PCM storage unit, Case 2 – SS with fins at the PCM storage unit, and Case 3 – SS with fins at the storage unit and a parallel plate attached to the other end of the fins. The experimental results demonstrated the production of fresh water and efficiency improvements are as follows 26.95%, 55.86%, 69.14% and 24.34%, 52.83%, 68.83% for cases I, II, and III, respectively. Further, it was observed that Case III exhibited a lower cost of water production and a shorter payback period compared to CSS. The enviro-economic analysis revealed that the net CO 2 emissions (NCEM) and Carbon Credits Earned (CCE) for Case III were 15.60 tons and 312.07 USD respectively against 9.22 tons and 184.31 USD for CSS.
Thulasimani et al. (Thu,) studied this question.