Key points are not available for this paper at this time.
Purpose Crossed helical gears have point contact and their surfaces are subject to high surface stress. Contact stress and root tooth stress are the most common sources of failure in crossed helical gear. This paper aims to study the load-carrying capacity and performance of crossed helical gear teeth with different gear tooth profiles. To overcome defects and reduce the sensitivity to small shaft angle changes. The combined tooth profile is designed to reduce the bending stresses, contact stresses and tooth deflection, and prevent pinion failure in the gearbox. Design/methodology/approach The principle of the method is a line contact is introduced instead of a point contact between two teeth in mesh with each other. The tooth surface of the helical gear is designed and cut by a modified tool. Higher normal pressure angles like 25° and 35° are used. The modified involute is accomplished to eliminate interference between the teeth. Engineering software packages have been applied to generate all crossed helical gears gear profiles. The modification is compounding curves consisting of an epicycloid-involute-hypocycloid gear teeth profile generated by the cutter modified. Findings The stresses in the crossed helical gear teeth profile were reduced by increasing the normal pressure angle values. Using a 35° pressure angle the enhancement percentage in contact stress and teeth fillet region will be about 29.345% and 15.421%, respectively. The best enhancement in a gear’s resistance is the epicycloid-involute-hypocycloid gear teeth profile. The enhancement was 32.610% and 18.588%. The skew in line of action in skewed helical gear will be sensitive when the crossing angles are small. Their teeth surface tends to be easily worn out; however, the wearing process will be reduced by using a proposed gear teeth profile. Practical implications The gear teeth to be modified are cut by a shaper process. The modifying rack cutter of this study can be used as a reference for creating a different helical gears sample. The helical teeth surface is modified to become an envelope of the other. This makes an original point contact change into a line contact. The epicycloid-involute-hypocycloid gear teeth profile is preferred for a higher contact ratio and a large load capacity. This work explicitly introduces a new method of kinematic consideration to improve the load capacity of crossed helical gear. Originality/value This paper showed some novel results by the unique shape of the rack-cutter designed to generate different helical angles and different gear positions. In the future, it will make valuable contributions to the further development of the dynamic performance of a crossed helical gear system through the study in the field of using asymmetric teeth profiles of helical gears with tip relief as the manner to enhance the crossed helical gear performance. Investigation of crossed helical gear by applying a predesigned parabolic function of transmission error enables the absorption of linear discontinuous functions caused by misalignment.
Abdulaal et al. (Tue,) studied this question.