Abstract Producing heat at high temperatures for industrial processes like chemistry, food, or paper is still achieved using fossil fuels. To reach net-zero CO2 emissions by 2050, as desired by the European Union, technology driven by renewable energy must emerge to electrify these sectors. For this reason, high-temperature heat pumps, based on a Reversed Brayton Cycle working with air, offer a promising solution. Indeed, nowadays, most high-temperature heat pumps are vapor compression cycles but they face several issues when a higher temperature is necessary (200 °C or more). The selection of refrigerant is challenging (high compression ratio and temperature limitation), and it has a non-negligible environmental impact. Nevertheless, the Reversed Brayton cycle still suffers from a low Coefficient Of Performance (COP) that could be improved by valorizing the cold heat flux produced in the cycle. In the literature, few works are related to this combined use of heating and cooling for sub-MWth applications, which is very important for the food industry (cooking and freezing). With this work, we aim to fill this gap by proposing an analysis of the achievable potential based on the 2nd law of thermodynamics using a generic model in Aspen Plus. Using a heat sink of 250 °C and 300 °C and a heat source of −10 °C, the potential of different cycles were analyzed by varying the secondary inlet temperature of the heat sink from 100 °C to 200 °C. For low inlet temperatures, the heating and total COP can reach a value of up to 1.3 and 1.66 respectively with an exergetic efficiency up to 54%. The COP decreases when the secondary inlet temperature of the heat sink increases while the exergy efficiency stays almost constant. A further increase does not allow to provide cooling anymore for lower outlet heat sink temperature.
Vankelekom et al. (Mon,) studied this question.
Synapse has enriched 5 closely related papers on similar clinical questions. Consider them for comparative context: