What type of study is this?

This is a Finite Element Analysis study (also classified as: Observational).

September 5, 2025Open Access

Finite element analysis of stress distribution in implant, abutment, screw and bone using different superstructure materials in implant-retained fixed partial dentures

MKMustafa Karakurt KBKöksal BeydemirDicle University BYBerivan Dündar YılmazDicle University

Key Points

Oblique forces caused more stress to the implant and surrounding tissues than vertical forces.
Stress distribution was analyzed using finite element analysis across various superstructure materials.
Titanium implants were placed in human mandibles, evaluating four different bridge prostheses materials.
Stress concentrations were primarily found at the neck area of the implant and around the crown margins.

Abstract

Aims: Aim of this study is to evaluate the stresses of the implant and implant surrounding tissues by using different superstructure materials by using the finite element method. Methods: In our study, titanium implants with a diameter of 3.3 mm and 4.8 mm were placed in the 2nd premolar and 2nd molar region of manadibula, respectively. Bone modeling was performed in order to analyse stress distribution by finite element method. 4 different 3-member bridge prostheses were designed by using porcelain fused metal, monolithic zirconia, porcelain fused zirconia and PEEK substructures on the titanium abutments. Analyzes were performed by vertical and oblique forces applied to the occlusal surface. Results: Oblique forces were found more destructive than vertical forces in all study groups. Stresses depending on the effect of the forces in the bone were affected by compression forces in 4 groups. Stresses in implant, abutment and screw were found around neck area. Stresses in crown were found around connector and margin areas. Conclusion: It is concluded that the stresses that occur as a result of the applied forces occur at least in zirconia generally.

Ask AI

Helpful

Bookmark

View Full Paper