The rapid growth of Internet-connected devices integrating into our everyday lives has no end in sight. As more devices and sensor networks are manufactured, security tends to be a low priority. However, the security of these devices is critical, and many current research topics are looking at the composition of simpler techniques to increase overall security in these low-power commercial devices. Transmission security (TRANSEC) methods are one option for physical-layer security and are a critical area of research with the increasing reliance on the Internet of Things (IoT); most such devices use standard low-power Time-division multiple access (TDMA) or frequency-division multiple access (FDMA) protocols susceptible to reverse engineering. This paper provides a hardware validation of previously proposed techniques for the intentional injection of noise into the phase mapping process of a spread spectrum signal used within a receiver-assigned code division multiple access (RA-CDMA) framework, which decreases an eavesdropper’s ability to directly observe the true phase and reverse engineer the associated PRNG output or key and thus the spreading sequence, even at high SNRs. This technique trades a conscious reduction in signal correlation processing for enhanced obfuscation, with a slight hardware resource utilization increase of less than 2% of Adaptive Logic Modules (ALMs), solidifying this work as a low-power technique. This paper presents the candidate method, quantifies the expected performance impact, and incorporates a hardware-based validation on field-programmable gate array (FPGA) platforms using arbitrary-phase phase-shift keying (PSK)-based spread spectrum signals.
Fletcher et al. (Fri,) studied this question.