What type of study is this?

This is a Quantitative Study study (also classified as: Experimental Study).

October 16, 2025Open Access

Quantification of small (1–10 µm) microplastic particles in soil matrices using automated scanning electron microscopy: possibilities and limitations

RKRälf KaegiSwiss Federal Institute of Aquatic Science and Technology MPMatthias PhilippSwiss Federal Institute of Aquatic Science and Technology IJIsabel S. JünglingTechnical University of Munich

Key Points

Automated scanning electron microscopy can detect microplastic particles, achieving around 70% recovery for polyethylene.
Monte Carlo simulations indicated optimal SEM conditions with 3 kV of acceleration voltage for better contrast.
Using gold coating on polycarbonate membranes improves detection of microplastics in complex soil matrices.
Density separation showed negligible presence of PVC in soil suspensions, underlining the complexity of microplastic detection.

Abstract

Abstract Scanning electron microscopy (SEM) provides superb resolution power and allows distinguishing microplastic particles (MPs) from other particles based on elemental ratios derived from energy dispersive x-ray (EDX) analysis. Polycarbonate (PC) membranes are typically used to isolate MPs from suspensions for SEM investigations. This, however, results in poor (atomic weight) contrast between MPs and the underlying PC membrane, challenging automated particle detection. To introduce an elemental contrast between MPs and the PC membrane, a gold (Au) coating was applied to the PC membrane before use. Monte Carlo simulations conducted to optimize operational conditions of the SEM suggest an acceleration voltage of 3 kV in combination with a 40 nm Au coating of PC membranes as most appropriate. Stock suspensions made from polyethylene (PE) fragments, polyvinyl chloride (PVC) fragments, and standard soils, all sieved to 0.45–10 µm, were mixed at different ratios. Selected mixtures were density separated to isolate the MPs from the mixtures. Whereas up to 7% of PE was detected in PVC stocks, likely representing false positives, only negligible amounts of PVC were detected in PE stocks. In soils, neither PE nor PVC was detected in significant amounts. Polyethylene and PVC particles diluted in soil suspensions at particle number ratios of 1:1:2 and 1:1:2000 were density separated, and largely concentration independent recoveries of around 70% and 50% were obtained for PE and PVC, respectively. Good agreement between SEM-EDX and Raman measurements was obtained for MPs, underlining the strength of our approach to address the smallest size fraction of MPs in complex matrices. Graphical abstract

Ask AI

Helpful

Bookmark

View Full Paper