Accurately characterizing the accumulated plastic deformation of the cement sheath is essential for evaluating wellbore integrity. Fiber Bragg Grating (FBG) technology, noted for its strong immunity to external interference, is employed for in situ monitoring under harsh downhole conditions. This study investigates the accumulated plastic deformation behavior of set cement through uniaxial cyclic loading–unloading tests and proposes a real-time, high-precision, and non-destructive monitoring scheme by integrating FBG sensors into the Casing–Cement–Formation system (CCFS). The results reveal that under uniaxial conditions, cumulative plastic strain increases with stress amplitude, with the plastic strain in a single cycle capable of reaching up to 0.2%. Under identical conditions, FBG measurements exhibit a drift phenomenon, resulting in an error margin of approximately 1.5–2%. Furthermore, within the CCFS, plastic strain exhibits linear accumulation during the initial 2–5 cycles, followed by a deceleration in the accumulation rate. This deceleration is attributed to the redistribution of internal stress induced by plastic strain accumulation. Notably, the addition of silica fume and latex significantly mitigates this deformation. Collectively, these findings validate the effectiveness of FBG technology for downhole integrity assessment and offer a pathway for early failure detection and targeted maintenance.
Cheng et al. (Thu,) studied this question.