Advanced packaging requires high-density interconnects with sub-10 μm design rules; however, conventional processes involving laser drilling and plasma desmearing increase dielectric surface roughness and degrade signal performance. A nanosecond ultraviolet (ns-UV) laser microvia process using a sacrificial metal barrier layer (SMBL) was developed to enable sub-10 μm via formation while preserving dielectric surface integrity. A Cu SMBL was introduced to block debris redeposition during laser irradiation and shield the dielectric from ion bombardment during plasma processing. By optimizing laser power, shot count, and SMBL thickness, approximately 8 μm microvias were formed in 10 μm thick Ajinomoto Build-up Film (ABF). The Cu SMBL facilitated heat dissipation, reducing the heat-affected zone and limiting lateral widening at the via entrance, resulting in improved via geometry and higher taper. The dielectric surface roughness increased significantly (>80 nm) when no SMBL was used during processing, whereas it remained nearly constant with the SMBL (Ra: 6.36 → 6.43 nm), thereby reducing current scattering at high frequencies. Adhesion of 0.46 kgf/cm was maintained after quick-via-pull testing without mechanical interlocking, with no interfacial separation observed, confirming reliable interconnect formation. Therefore, the SMBL process enables precise microvia fabrication and low-loss interconnects for high-frequency packaging.
Park et al. (Wed,) studied this question.