What question did this study set out to answer?

This research focuses on processing nitinol powders for additive manufacturing and assessing their suitability for medical applications.

June 17, 20260 citationsOpen Access

AM of NiTi for medical applications

JLJannis Lemke ACAlberto Coda

Key Points

This research focuses on processing nitinol powders for additive manufacturing and assessing their suitability for medical applications.
Characterization of Nitinol powders produced via electrode induction melting gas atomization and vacuum induction melting gas atomization.
Detailed analysis using microscopy, chemical analysis, differential scanning calorimetry (DSC), and X-ray diffraction (XRD).
Evaluation of the functional properties of parts fabricated through laser powder bed fusion (LPBF) before and after heat treatment.
Nitinol powders showed significant compositional sensitivity; a 0.1 at.% Ni loss led to a 10 °C shift in transformation temperatures.
Oxygen levels exceeding 500 ppm resulted in oxide formation, significantly reducing the fatigue life of parts.
Fabricated parts demonstrated changes in transformation behavior when compared to original powders, indicating modification through additive manufacturing.

Abstract

Additive manufacturing (AM) of superelastic Nitinol represents a promising field of research, as its freeform capabilities and potential for customization may enable the development of a new generation of medical implants and devices. However, the use of additive processes for fabricating Nitinol components presents several challenges due to the functional nature of NiTi as a material. Processes such as laser powder bed fusion (LPBF) can lead to preferential evaporation of nickel or oxidation of titanium. These effects are particularly critical because the material is highly sensitive to compositional variations; even a loss of 0.1 at.% Ni can shift transformation temperatures by approximately 10 °C. Furthermore, if oxygen levels exceeding 500 ppm, oxide formation can significantly reduce fatigue life and lead to premature failure. Therefore, it is essential to use high-purity feedstock powders with tightly controlled chemical composition. In this work, we present our experience and approach to the preparation and processing of NiTi powders for LPBF. Powders produced via electrode induction melting gas atomization (EIGA) and vacuum induction melting gas atomization (VIGA) are characterized, and both technologies are evaluated in terms of their suitability for AM processing. Key aspects of these processes are discussed. In the second part of the study, multiple powder batches were prepared in-house using EIGA. These powders were characterized through microscopy, chemical analysis, differential scanning calorimetry (DSC) to determine transformation temperatures, and X-ray diffraction (XRD) to verify phase composition. Results from fabricated parts are presented in the as-built condition and after heat treatment, and are compared with the transformation behavior of the original powders. The parts were manufactured via LPBF, their functional properties were evaluated and compared to previously reported results. Finally, key considerations for the application of AM-processed NiTi in the medical field are discussed.

Ask AI

Helpful

Bookmark

View Full Paper