Key points are not available for this paper at this time.
This paper compares different uniaxial and biaxial graded designs of auxetic reentrant honeycomb structures to enhance their mechanical properties, especially the specific energy absorption under compressive load. The lattice structures were 3D printed using the vat photopolymerization masked-stereolithography technique from two different materials – tough (OR) and flexible (FR). The results were evaluated from a material and structural point of view, investigating the effect of porosity, cell number, size, graded design, and fracture mode. The universally best energy-absorbing performance was found in a biaxially graded structure with a center-wise location of the highest local porosity. Depending on the used resin, its energy absorption capacity was up to 2–3 times enhanced compared to a reference uniform-porosity auxetic design. The presented data constitutes a fundamental understanding of auxetic structures and identifies practical approaches for tuning the auxetic structures' performance regarding their mechanical response. Finally, this study demonstrates the potential of shape versatility offered by 3D printing and other additive manufacturing techniques.
Štaffová et al. (Thu,) studied this question.