Fast co-pyrolysis of wood and plastic: Evaluation of the primary gaseous products

Bio-oil derived from fast pyrolysis of wood contains oxygenates and has a relatively low heating value.These are challenges that need to be tackled if wood-derived bio-oil is to be used as drop-in fuels.The bio-oil can be obtained by condensation of gaseous products.Using a material with no oxygen in addition to wood during fast pyrolysis could be a technique to reduce the formation of oxygenates and promote a hydrocarbon-rich product.This work aims to evaluate the primary gaseous products formed during fast co-pyrolysis of birch wood and plastic.The pyrolysis was performed in a micropyrolyser at 600 • C with a residence time of 5 s.Birch wood and plastic were melt-mixed at different weight ratios to study possible interaction effects upon pyrolysis.The different plastics used were low-density polyethylene (LDPE), polypropylene (PP) and polystyrene (PS).The total gaseous product was between 10-20 wt% from Wood-LDPE or Wood-PP, while it was in the range 15-90 wt% from Wood-PS.The analysis of gas product found that the formation of oxygenates (up to 9 wt%) was lower than expected (up to 14 wt%) for the mixtures of wood and plastic compared to the pure materials (about 18 wt%).The reduction of oxygenates (up to 90 %) was mainly due to a lower production of ketones, carboxylic acids and aldehydes.Maximum hydrocarbons in the gas phase from binary mixtures were around 8, 15 and 55 wt% from Wood-LDPE, Wood-PP and Wood-PS, respectively.The most significant difference between experimental and estimated values assuming no interaction among hydrocarbons was observed in the case of alkenes and alkanes for Wood-LDPE, as well as alkanes for Wood-PS, while the Wood and PP mixture showed almost no signs of interaction.This work is beneficial for understanding interactions between wood and plastics, and could be used to reduce the amount of oxygenates from wood pyrolysis and reduce the need for upgrading.