Microstructural characteristics and recrystallization mechanism of Ti-6.5Al–2Zr–1Mo–1V alloy during two-stage hot deformation

In this study, we investigated the two-stage deformation behavior of near α Ti-6. 5Al–2Zr–1Mo–1V alloy at various temperatures (915 °C, 950 °C, 1020 °C) and strain rates (0. 01 s−1, 0. 1 s−1). The alloy underwent differing holding periods (500s, 1000s) between deformation stages. The results demonstrated an increase in flow stress with decreasing deformation temperature and increasing strain rate. Work hardening of flow stress was observed during the two-stage thermomechanical processing within the α+β two-phase region. Microstructural evolution was characterized by the formation of α lamellar kink bands, the separation and migration of grain boundaries, and grain spheroidization. An increase in deformation temperature and a decrease in strain rate enhanced grain refinement, accelerated structural evolution, and intensified the degree of spheroidization. Dynamic recrystallization (DRX) was more prevalent at higher temperatures and lower strain rates, as the critical nucleation rate for DRX was more readily achieved. The increased interval between thermomechanical processing stages led to a transition from low-angle to high-angle grain boundaries, and a reduction in dislocation density due to static recovery occurred during the holding period. At 915 °C, hot deformation induced the formation of 10-10 twinning, altering grain orientation and reducing stress. The Schmid factor for 10-10 slip was higher at lower temperatures, which reduced the critical resolved shear stress necessary for yielding in the α phase of the Ti-6. 5Al–2Zr–1Mo–1V alloy, thereby facilitating further plastic deformation.