Pyrolysis of polypropylene (PP) and high density polyethylene (HDPE) into fuel like products was investigated over temperature range of 250– 400°C. The product yields as a function of temperature were studied. Total conversion as high as 98.66% (liquid; 69.82%, gas; 28.84%, and residue; 1.34%) was achieved at 300°C in case of PP and 98.12% (liquid; 80.88%, gas; 17.24%, and residue; 1.88%) in case of HDPE at 350°C. The liquid fractions were analyzed by FTIR and GC-MS. The results showed that the liquid fractions consisted of a wide range of hydrocarbons mainly distributed within the C6–C16. The liquid product obtained in case of PP is enriched in the naphtha range hydrocarbons. Similarly, the liquid product obtained in case of HDPE is also enriched in naphtha range hydrocarbons with preponderance in gasoline and diesel range hydrocarbons. The% distribution of paraffinic, olefinic, and naphthenic hydrocarbons in liquid product derived from PP is 66.55, 25.7, and 7.58%, respectively, whereas in case HDPE, the% distribution is 59.70, 31.90, and 8.40%, respectively. Upon comparing the hydrocarbon group type yields, PP gave high yield of paraffinic hydrocarbons while HDPE gave high yields of olefins and naphthenes. The whole liquid fractions and their corresponding distillates fractions were also analyzed for fuel properties. The results indicated that the derived liquid fractions were fuel-like meeting the fuel grade criteria.
Ahmad et al. (2014) studied this question.