PulseExploreJournal ClubDebatesTrendingResearchersJournals
Instagram
HomeExploreJournal ClubTrending
Synapse
⌘+K
Synapse
November 24, 2025International Journal of Heat and Fluid Flow2 citationsOpen Access

Flow-induced vibration of an elastically mounted oblate spheroid with variable mass ratio

View Full Paper
AOAdrian Cordero ObandoKHKerry HouriganMTMark C. Thompson

Key Points

Key points are not available for this paper at this time.

Abstract

This study experimentally investigates the cross-flow flow-induced vibration (FIV) of an elastically mounted oblate spheroid with an aspect ratio of 2. The aspect ratio is defined as the ratio of the major diameter ( b ) in the cross-flow direction to the minor diameter ( a ) in the streamwise direction, namely ϵ = b / a . The FIV response was characterised over a range of reduced velocity, 3 . 0 ⩽ U ∗ = U / ( f n w b ) ⩽ 12 . 0 , where U is the free-stream velocity and f n w is the natural frequency of the system in quiescent water. The corresponding Reynolds number varied over the range 5000 ⩽ R e = U b / ν ⩽ 20 000 , with ν denoting the kinematic viscosity of the fluid. The mass ratio of the hydro-elastic system, defined as the ratio of the total oscillating mass ( m ) to the displaced fluid mass ( m d ), namely m ∗ = m / m d , was varied from 32 to 250, while the mass-damping parameter ( m ∗ + C A ) ζ was kept almost constant at 0.20 for all the m ∗ values tested, with C A being the potential added-mass coefficient. The results reveal that the dynamic response exhibits two distinct FIV phenomena: vortex-induced vibration (VIV) and galloping-like vibration. The VIV region is characterised by a roughly bell-shaped and bounded amplitude of vibration response as a function of reduced velocity. The peak normalised vibration amplitude was observed to be A 10 ∗ = 0 . 70 . On the other hand, the galloping region is characterised by a linear increase in the amplitude response with increasing U ∗ beyond a critical value of U ∗ = 7 . 0 , reaching a maximum value of A 10 ∗ ≈ 2 at the highest reduced velocity tested U ∗ = 12 . Interestingly, maintaining a constant value for ( m ∗ + C A ) ζ while varying m ∗ results in a maximum amplitude response almost identical across a wide range of m ∗ , similar to VIV of circular cylinders. Moreover, it was found that m ∗ = 32 displayed a hard-galloping-like (i.e. the onset of vibration triggered by a finite amplitude disturbance) response, while for m ∗ ⩾ 50 the response was characterised by a soft-galloping-like (i.e. small-amplitude excitation from rest) response.

Ask AI
Helpful
Bookmark
Share
View Full Paper

Cite This Study

Obando et al. (2025) studied this question.

synapsesocial.com/papers/6a7161b975498292b70ada6dhttps://doi.org/10.1016/j.ijheatfluidflow.2025.110129
Ask AI
Helpful
Bookmark
Share
View Full Paper