The wheat planted at the end of the rainy season in the Cerrado suffers from a strong water deficit. A selection of genetic material with drought tolerance is necessary. In improvement programs that evaluate a large number of materials, efficient, automated, and non-destructive phenotyping is essential, which requires the use of sensors. The experiment was conducted in 2016 using a phenotyping platform, where irrigation gradients ranging from 184 (WR4) to 601 mm (WR1) were created, allowing for the comparison of four genotypes. In addition to productivity, we evaluated plant height, hectoliter weight, the number of spikes per square meter, ear length, photosynthesis, and the indices calculated by the sensors. For most morphophysiological parameters, extreme stress makes it difficult to discriminate materials. WR1 (601 mm) and WR2 (501 mm) showed similar trends in almost all variables. The data validated the phenotyping platform, which creates an irrigation gradient, considering that the results obtained, in general, were proportional to the water levels. The similar trend between sensors (NDVI, PRI, and LIFT) and morphophysiological, plant growth, and crop yield evaluations validated the use of sensors as a tool in selecting drought-tolerant wheat genotypes using a non-invasive methodology. Considering that only four genotypes were used, none showed absolute and unequivocal tolerance to drought; however, each genotype exhibited some desirable characteristics related to drought tolerance mechanisms.
Soares et al. (Thu,) studied this question.