What type of study is this?

This is a Quantitative Study study.

September 16, 2025Open Access

Orphaned oil and gas well methane emission rates quantified using Gaussian plume inversions of ambient observations

Key Points

Methane emissions from abandoned oil and gas wells total approximately 2.6 Tg annually, affecting climate and air quality.
The Gaussian plume method estimated a methane leak rate of 10.53 kg CH4 h−1 during venting, significantly reducing previous error estimates.
In situ measurements improved accuracy of methane flux quantification to within 15%, enhancing standard practices for well remediation.
Findings highlight the necessity for standardized emission quantification methods to effectively prioritize orphaned well remediation efforts.

Abstract

Abstract. Annually, ∼ 3.6 million abandoned oil and gas wells in the US emit a combined ∼ 2.6 Tg methane (CH4), adversely affecting climate and regional air quality. However, these estimates depend on emission factors derived from measuring subpopulations of wells that vary by orders of magnitude due to very limited field sampling and poorly characterized distributions. Currently, US protocols to remediate orphaned wells lacks standardized quantification methods needed to both prioritize plugging and account for emission reductions. Therefore, sensitive, reliable, affordable, and scalable CH4 flux quantification methods are needed. We report the use of a simple Gaussian plume method where the dispersion parameters are constrained by in situ ground measurements of CH4 concentration at four locations 7.5–49 m downwind of the orphan well as well as local winds to estimate the leak rate from an orphan well. We derive a flux of 10.53 ± 1.16 kg CH4 h−1 during a venting procedure in April 2023 that agrees with the directly measured volumetric flow rate of 9.00 ± 0.25 kg CH4 h−1. This is 71 % greater than the 5.3 kg CH4 h−1 flux measured 7 months prior. Additionally, we discovered a secondary leak through the surface casing inferred as 0.43–0.67 kg CH4 h−1 both by our ground Gaussian analysis and by transecting the plume with an uncrewed aerial system (UAS). We show that in situ determination of the dispersion parameters used in our Gaussian inversions allows us to measure methane emissions to 15 % accuracy, significantly reducing errors when compared to the standard practice of assuming stability class. Our results help develop simpler methods and protocols for robust orphan well emission quantification that can be used for reporting.

KI fragen

Bookmark

View Full Paper