Key points are not available for this paper at this time.
Abstract The strength and failure of rock masses are ambiguous due to their complex structure. Investigating the strength and failure of jointed rock mass remains a persistent concern in mining engineering. This study aims to investigate the effects of joint dip angles of complex discrete joints on the mechanical properties and fracture evolution of rock‐like material. Rock‐like specimens with complex joints were prepared using 3D printing technology and then tested under uniaxial compression loading. The experimental results reveal the following findings: (1) The anisotropy of rock‐like material with complex joints is lower compared to the rock‐like material with simple joints. (2) The ratio of long‐term strength to uniaxial compressive strength of rock‐like material remains consistent despite changes in the dip angle of the joints. (3) Differing from intact rocks, AE events of the rock‐like material with complex joints are obvious in the initial loading stage and elastic deformation stage. (4) When the dip angle of the joint sets is 0 and 90°, fractures progressively propagate, and the failure mode of the rock‐like material demonstrates tensile failure along the pre‐existing joints. Conversely, when the dip angle of the joint sets is 45° and 135°, fractures are simultaneously initiated at various locations within the rock‐like specimen, resulting in a failure mode of rotational failure by the newly generated block.
Tang et al. (Mon,) studied this question.