Assessing wayside traffic noise levels using long-term noise monitoring and available Department of Transportation traffic data - worst-case noise traffic conditions, effects of repaving, and methods for comparing traffic noise data sets

The availability of automated continuous traffic data from State Departments of Transportation (DOTs), such as the California Department of Transportation (Caltrans) Performance Measurement System (PeMS), provides increased opportunities for the analysis of highway noise. Traffic data that is free to access and downloadable via the internet can be matched with unattended long-term noise measurement data to provide large datasets for analysis, without requiring field staff to be continuously on site. A 2018 ICF/Caltrans paper documented how this approach was used on an operating freeway to determine the volume of traffic that results in the highest one-hour energy average traffic noise level. At the time of those measurements, the subject freeway had Portland cement concrete pavement. The freeway has since been repaved with an open-graded rubberized asphalt concrete pavement overlay. The current study uses new (2023) traffic noise measurements and PeMS data to investigate how worst-noise conditions have changed and the effect of the repaving on wayside noise levels. Changes in traffic patterns since 2018 required the authors to normalize the measurement data for comparison. Opportunities were identified to take advantage of the large measurement data sets to match before-and-after data, and those methods are also described in this paper.