Key points are not available for this paper at this time.
Abstract The achievement of high gain, stationary conditions in a tokamak scenario aimed at producing fusion energy in the ITER Project is crucial to the demonstration that this form of energy can be used in future reactors to provide cheap and clean energy globally. Disruptions are a challenge for the fusion energy field, in particular for the ‘ITER Baseline Scenario’ (IBS), as reproduced in the DIII-D tokamak. This work shows that a solution has been found for the m = 2/ n = 1 tearing modes that have consistently caused disruptions in the IBS: stable operation down to zero input torque was achieved by modifying the current density profile at the beginning of the pressure flattop and the ELM character later in the discharges, guided by previous results showing that the most likely cause of these instabilities is the current density profile. The coupling between sawteeth, n>2 modes and the 2/1 TMs is shown to not be statistically significant, nor the leading origin for the evolution towards instability. Ideal and resistive MHD modeling provide positive verification that a steeper ‘well’ in the region of the q = 2 rational surface leads to worse ideal stability, higher tearing index Δ’ and lower threshold Δ’ c for resistive instabilities, consistent with the experimental results. This provides confidence that the methods used in this work can be extrapolated to other devices and applied to avoid disruptions in ITER and pulsed fusion devices worldwide.
Turco et al. (Tue,) studied this question.