Key points are not available for this paper at this time.
The vacuum-assisted prefabricated horizontal drain offers a promising method for strengthening soil slurry, allowing simultaneous filling and vacuum-dewatering via staged construction. However, there is limited research on the unique characteristics of staged filling. This study aims to investigate the vacuum consolidation process of staged-filled soil slurry through laboratory model tests and numerical simulations, also assessing the impact of anionic polyacrylamide. Comparative analyses are conducted between vacuum consolidation with and without anionic polyacrylamide, as well as self-weight consolidation without anionic polyacrylamide. Results reveal contour lines of excess pore pressure, water content, and soil strength forming an ellipse around the prefabricated horizontal drain board. During the consolidation process, a higher degree of consolidation, lower water content, and higher soil strength were observed closer to the prefabricated horizontal drain board. After treatment, the uppermost filling layer exhibits an average water content that was approximately 40% higher than the lower filling layer, and its average strength was about 60% lower. This discrepancy is primarily due to the absence of sealing on the top surface and the relatively short vacuum consolidation time caused by staged filling. The introduction of anionic polyacrylamide-induced flocculation significantly improves the initial consolidation rate but minimally affects the dewatering capacity of vacuum preloading. Using flocculant can enhance both the staged filling rate and soil strength (by 1-2 times). Additionally, employing a staggered arrangement between different prefabricated horizontal drain layers is advisable to prevent top-down penetration in areas with low soil strength.
Song et al. (Sat,) studied this question.