Key points are not available for this paper at this time.
While most of the influences on the mechanical properties of particleboard appear to have been investigated, there is a lack of knowledge about the influence of particle size or particle dimensions due to the absence of a suitable particle measuring technique. The introduction of laser-based 3D scanning technology makes it possible to automatically determine the dimensions, surface area, and volume of particles. In this study, the influence of particle size on the mechanical properties of particleboards was investigated. To isolate potentially overlapping influences, single-layer particleboards with a uniform density profile were produced and analyzed. The amount of adhesive specific to the surface of the (fine) face layer particles and (coarse) core layer particles was adjusted utilizing 3D scanning of the surface areas to ensure comparability despite changes in particle size. It was found that with increasing particle size, the modulus of rupture (MOR) and modulus of elasticity (MOE) increase, while the internal bond strength (IB) decreases. It is considered whether these effects result from a particle-size-dependent orientation of the particles in the board. Furthermore, it is shown that all the aforementioned properties increase with increasing surface-specific adhesive amounts. Examples are provided to demonstrate how such fundamental relationships can be utilized to enhance the particleboard production process.
Engehausen et al. (Tue,) studied this question.