To investigate the performance of skewed roller thrust bearings (SRTBs) in the no-back brake of horizontal stabilizer trim actuators (HSTAs), this study conducts systematic theoretical modelling, experimental validation, and numerical simulation focusing on torque and contact characteristic optimization. First, a theoretical model for resistance torque of the SRTB was established based on the kinematics and load behaviours, followed by a systematic investigation into the effects of roller centre position and skew angle on the bearing’s resistance torque. An experimental platform was built, and tests were carried out on the bearings to verify the results of the theoretical analysis. Subsequently, a tangent arc profile was applied to the rollers to mitigate stress concentration at their ends, and the influences of crown drop and straight segment length on roller contact stress were explored by finite element method. Finally, considering the actual operating conditions of no-back brake components, the effect of roller centre position on brake deformation and roller contact stress was studied. The results show that the resistance torque increases with both roller skew angle and centre position, but is insensitive to rotational speed. Roller contact stress first decreases rapidly and then increases gradually with crown drop, indicating the existence of an optimal crown drop value. This optimal value first decreases and then increases with increasing straight segment length, with the optimal parameters determined as 9 μm (crown drop) and 4 mm (straight segment length). In practical applications, asymmetric loading on the two sides of the ratchet disc causes uneven roller contact distribution and stress concentration. Adjusting the roller centre position to balance the deformation of the ratchet disc and rod shoulder can effectively reduce contact stress, with the optimal position being approximately 48 mm (slightly offset from the load centre of 49 mm). This study provides valuable insights for the optimal design of SRTBs and no-back brakes.
Ren et al. (Thu,) studied this question.