Abstract Compared to conventional subtractive or formative manufacturing techniques, additive manufacturing (AM) offers increased geometric freedom, enhanced structural efficiency and greater automation. Hybrid construction, which combines conventionally produced structural components (e.g. hot‐rolled steel tubes) with additively manufactured parts (e.g. optimised joints), is deemed to be the most practical way to deploy metal AM in construction. This study focuses on developing an optimisation methodology that combines topology optimisation, reengineering and measures to enhance printability. During the topology optimisation phase, the printability of the optimised part is considered by imposing stress and overhang constraints, preventing the formation of overly slender elements and excessive overhang angles. In the reengineering phase, printability is further improved through manual adjustments to satisfy manufacturing constraints. Following its development, this methodology was applied to generate optimised X‐shaped tubular joints, which were subsequently printed by means of wire arc additive manufacturing (WAAM). The structural performance of the printed joints, including the initial stiffness, ultimate load‐bearing capacity, ductility and material efficiency, was assessed through geometrically and materially nonlinear numerical analyses and verified by physical experiments.
Zhang et al. (Mon,) studied this question.