Understanding the crack development and rainfall infiltration in loess under wetting–drying cycles is crucial for assessing slope stability and promoting sustainable land management in ecologically vulnerable regions. This study employed a three-dimensional column model (Φ24 × 50 cm) with 64 buried electrodes to simulate short-term heavy rainfall by changing the light duration (10 h/d and 5 h/d) and using 100 mm rainfall water. Results indicate that dry–wet cycles cause cumulative damage, significantly altering soil infiltration properties. After four cycles, the rainfall infiltration recharge coefficient increased from an initial 0.44% to 45.58%, a more than 100-fold rise. Resistivity imaging revealed a shift in water transport mode: from uniform matrix flow initially to preferential flow dominated by crack networks as cracks developed. During drying, crack zones exhibited high resistivity (ρ > 150 Ω·m), while water-filled cracks during infiltration showed low resistivity (ρ < 50 Ω·m). Resistivity is an excellent comprehensive index to quantify multi-field coupling damage, and its change (ρ∝ 1/w1.86 × 1/(1 + 0.032 width)) synchronously responds to water content, crack development and dry–wet process. Low water content (w < 15%) and medium crack width (4–6 mm) are the most sensitive states. Longer illumination (10 h/d) promoted greater crack development and higher infiltration capacity compared to shorter cycles (5 h/d). The developed resistivity–moisture relationship provides a non-destructive monitoring tool for slope moisture dynamics, supporting not only geotechnical stability assessment but also optimized irrigation scheduling and adaptive land-use planning. These insights contribute directly to the sustainable management of soil and water resources in loess landscapes, aligning with sustainability goals in fragile ecosystems.
Zhang et al. (Thu,) studied this question.