Phase-change materials (PCMs), such as paraffin wax, are widely used in latent heat storage (LHS) because they store substantial thermal energy at nearly constant temperature; however, their low thermal conductivity limits heat transfer and slows melting/solidification. In this work, two flat-plate solar collectors are coupled with a paraffin-based LHS unit for low-temperature solar heating, and the design is optimized by introducing improved fin-geometry combinations on both the heat transfer fluid (HTF) tube and shell side. The M-shaped fins combined with rectangular fins significantly enhanced convective heat transfer by generating localized vortices, while the extended surface area improved conduction within the solid PCM, facilitating efficient heat dissipation and accelerating the phase transition. The LHS unit without fins showed complete melting in 67 min. However, fin introduction remarkably mitigated charging duration to 44 min, 52.3% faster than bare tubes having no fins. The experimental melting process exhibited a 7 min delay by comparing experimental and numerical results, achieving complete melting in 51 and 44 min, respectively. Discharging was completed in 48 min. During PCM charging, sensible heating produces a rapid temperature rise with only a small energy increase, but once the PCM entered into the melting range (320–324 K), the energy changed more steeply. Adding fins boosts stored energy from 2.10 MJ to 3.25 MJ (54.8%) and exergy from 0.15 MJ to 0.27 MJ (80.0%), yet exergy remains far smaller than energy (92.9% lower without fins and 91.7% lower with fins), indicating fins enhance total heat storage more than recoverable work potential.
Shazad et al. (Mon,) studied this question.