Key points are not available for this paper at this time.
The effects of hot deformation strain rates and temperatures on aluminium alloys' dynamic recovery and recrystallisation mechanisms have been widely discussed in the literature. However, their influence remains controversial due to a need for comprehensive and detailed thermomechanical testing and characterisation data across a wide range of hot deformation conditions. In this study, hot compression tests of AA7050 were conducted at strain rates of 0.0005–5 s −1 and temperatures of 380–460 °C. The geometrically necessary dislocation (GND), low-angle grain boundary (LAGB) and high-angle grain boundary (HAGB) were acquired by the latest high angular resolution, high-speed EBSD detector (OI Symmetry 2), and their underlying mechanisms were analysed in relation to Zener-Hollomon parameter ( Z ). It was found that within the tested range of the hot compression condition (ln ( Z ) between 20.23 and 29.45), continuous dynamic recrystallisation (CDRX) predominates at lower ln ( Z ) values with its activity being initially increased and then decreased as ln ( Z ) rises, while discontinuous dynamic recrystallisation (DDRX) becomes dominant at higher ln ( Z ) levels. This transition of the dominant mechanism is intriguingly reflected in the evolution of HAGB length, which increases, then decreases and finally increases again. The LAGB length shows a relatively linear relationship with ln ( Z ), and the average GND density exhibits a near-linear correlation until reaching a plateau. Based on the obtained results, the transformation of the dominant microstructural evolution mechanisms with increasing ln ( Z ) was clarified: from grain growth, to recovery, to CDRX, and then to DDRX, along with the quantitative trend of HAGB length per unit area. This transformation mechanism is believed to encompass the full range of material processing window, providing a basis for justifying the previous controversial proposition in literature and a guide for defining and fabricating microstructures in manufacturing applications.
Jiang et al. (Thu,) studied this question.