Electrically conductive photopolymers enable the fabrication of functional 3D-printed components with customized electrical properties, expanding additive manufacturing applications beyond traditional structural uses. This study reports the formulation and characterization of electrically conductive, water-washable photopolymer resins for masked stereolithography (MSLA) through the incorporation of nano-graphite, PEDOT:PSS, and dimethyl sulfoxide (DMSO) as a secondary dopant. Single filler and hybrid resin systems were prepared and processed via MSLA printing, then subjected to sequential thermal treatments, 25 °C curing for 48 h followed by annealing at 80 °C and 120 °C, to investigate conductivity enhancement and microstructural evolution. Electrical characterization via current–voltage (I–V) measurements, referenced to the transversal conductivity (σTRA), showed that the hybrid formulation containing PEDOT:PSS, graphite, and DMSO achieved the highest conductivity (9.40 × 10−2 S·cm−1), outperforming PEDOT:PSS/graphite systems (2.6 × 10−3 S·cm−1) and graphite-only samples (9.76 × 10−4 S·cm−1). Conductivity increased consistently after each thermal step, indicating enhanced charge transport. Scanning electron microscopy further revealed improved filler dispersion and interconnectivity within the polymer matrix. The synergistic combination of PEDOT:PSS, graphite nanofillers, and DMSO enables MSLA printed components with tunable and reproducible electrical performance. This work demonstrates a scalable strategy for producing functional, water-washable photopolymer resins suitable for applications in sensors, soft electronics, and lightweight conductive structures.
Conti et al. (Thu,) studied this question.