Key points are not available for this paper at this time.
A series of cyclic surfactants were synthesized from a poly(ethylene glycol) (PEG) homopolymer and Pluronic surfactants L35, L64, P123, F68, 10R5, and 17R4, and their interfacial activity depending on the topology, chain ends, and block sequence was investigated. The cyclization was performed in a single step through etherification of the PEG homopolymer and the hydrophilic–hydrophobic–hydrophilic (ABA type) poly(ethylene glycol)–poly(propylene glycol)–poly(ethylene glycol) (PEG–PPG–PEG), while the hydrophobic–hydrophilic–hydrophobic (BAB type) PPG–PEG–PPG was cyclized via acetalization. The cyclized surfactants were rigorously characterized by nuclear magnetic resonance spectroscopy and size exclusion chromatography. Cyclization of the surfactants induced a significant decrease in the hydrodynamic volume, which was more pronounced than that of the PEG homopolymer. Surface tension (γ) measurements indicated that the interfacial activity of the cyclized surfactants is stronger than their corresponding linear precursors, due to the increase in the surfactant density at the air–water interface as a consequence of the decreased molecular occupational area (A) upon cyclization. In the case of the PEG homopolymer, A considerably decreased from 410 Å2 for the linear PEG prepolymer to 100 Å2 for the cyclized PEG product. While the effects of chain-end groups were found to be limited to surfactants of relatively small molecular weights, the influence of cyclization depended strongly on the hydrophilic/hydrophobic ratio; the higher the PEG composition the surfactants had, the larger the decrease in γ and A; in other words, stronger enhancement in the interfacial activity was observed.
Watanabe et al. (Fri,) studied this question.