Key points are not available for this paper at this time.
Multi-material structures with variable functionalities can lead to unique solutions for engineering problems compared to single-material structures. Additive manufacturing of Functionally Graded Materials (FGMs) using Direct Laser Deposition for the multi-material deposition of Stellite6 and 17–4 PH stainless steel has been investigated in this study. Process parameter design was successfully applied to achieve FGM structures with expected composition ratio and defect free. Results revealed that clads with insufficient laser power had unmelted 17-4 PH powders, while those with excessive power resulted in micro-cracks and disrupting the expected composition for the previous layer. Energy Dispersive Spectroscopy analysis results showed that the composition was almost as expected, with less than 10% deviation. The Stellite6 composition in FGM exhibits a minimum ratio near the substrate due to the penetration of 17-4 PH elements. Meanwhile, in multi-track clads, the Stellite6% decreases along the transverse direction due to increased heat input, multiple cladding tracks, higher dilution, and slower solidification rate. The results of the micro-hardness tests illustrated the gradual evolution of micro-hardness along the build direction starting from the base metal, which had a hardness of approximately 300 HV for 17-4 PH and for the compositions of 25%, 50%, 75%, and 100% Stellite6 showed increases of 10%, 39%, 43%, and 63% respectively, reaching up to 490 HV for fully Stellite6 at the top of the specimen.
Ilanlou et al. (Fri,) studied this question.