Key points are not available for this paper at this time.
Multi-facet heliostats are more versatile and advantageous in design compared to single facet heliostats, while generating new design challenges. Multi-facet designs can reduce manufacturing costs, allow for decentralisation of power supply, and bring the option of face down stow. Addition of a gap between two facets, changes the flow structure around the heliostat. The effect of gap between two heliostat facets is therefore investigated on wind loads through experimental investigation in a large wind tunnel. A heliostat model was placed in a simulated atmospheric boundary layer at The University of Adelaide wind tunnel. The investigation covered gap ratios between two panels (gap spacing/facet width) from 0 to 2, and panel aspect ratios (facet width/chord length) of 0.35 to 0.65, forming a complete heliostat aspect ratio of 0.7 to 1.3 with no gap. Wind load coefficients were determined using load cell measurements at the base, and application of differential pressure sensors on the surface, of the heliostat model. Findings indicate the presence of a gap, in general, increases the wind load on the heliostat, with facet aspect ratio exacerbating the results. The maximum load cases shift further into the operating range of heliostats where a change in centre of pressure, due to a change in gap ratio, shifts maximum coefficients from an elevation angle of 30° to 45° for lift force and hinge moment, and 90° to 75° for azimuthal moment. Increasing loads on elevation and azimuth drives potentially increases tracking deviations and beam misalignment, reducing concentrated solar power plant performance.
Marano et al. (Fri,) studied this question.