Vertical axis wind turbines (VAWTs) are promising systems for urban wind energy applications because of their compact layout, omni-directional operation, and favorable integration potential. However, their broader deployment remains limited by poor self-starting capabilities and relatively low aerodynamic efficiency compared to horizontal axis wind turbines. In this study, a passive flow control concept for a straight-bladed VAWT is numerically investigated using a NACA0012 airfoil modified with 45° inclined perforations on the extrados. Four perforated configurations were generated and compared with the baseline profile through a two-stage computational approach. First, steady 2D computational fluid dynamics (CFD) simulations of the isolated airfoils were performed at a free stream velocity of 12 m/s over an angle of attack range of 0–180°. Subsequently, the most relevant aerodynamic trends were assessed at rotor level using transient 2D Moving Mesh simulations for a three-bladed wind turbine with tip speed ratios (TSRs) between 0.5 and 3.5. All perforated variants exhibited higher lift than the baseline airfoil, while the configuration with smaller, denser perforations distributed over the downstream two-thirds of the extrados provided the best overall aerodynamic performance. At TSR = 2.5, this geometry increased the mean moment coefficient from 0.044 to 0.0525 and the power coefficient from 0.109 to 0.131, corresponding to an increase in power output of approximately 20%. These results indicate that inclined extrados perforations constitute a promising passive strategy for improving the aerodynamic performance of small straight-bladed VAWTs, although further 3D and experimental validations are required.
Bucur et al. (Fri,) studied this question.