Key points are not available for this paper at this time.
Abstract The power conversion efficiency (PCE) of perovskite solar cells (PSCs) has now exceeded 20%; thus, research focus has shifted to establishing the foundations for commercialization. One of the pivotal themes is to curtail the overall fabrication time, to reduce unit cost, and mass‐produce PSCs. Additionally, energy dissipation during the thermal annealing (TA) stage must be minimized by realizing a genuine low‐temperature (LT) process. Here, tin oxide (SnO 2 ) thin films (TFs) are formulated at extremely high speed, within 5 min, under an almost room‐temperature environment (<50 °C), using atmospheric Ar/O 2 plasma energy (P‐SnO 2 ) and are applied as an electron transport layer of a “n–i–p”‐type planar PSC. Compared with a thermally annealed SnO 2 TF (T‐SnO 2 ), the P‐SnO 2 TF yields a more even surface but also outstanding electrical conductivity with higher electron mobility and a lower number of charge trap sites, consequently achieving a superior PCE of 19.56% in P‐SnO 2 ‐based PSCs. These findings motivate the use of a plasma strategy to fabricate various metal oxide TFs using the sol–gel route.
Yu et al. (Fri,) studied this question.