Key points are not available for this paper at this time.
With the increasing use of high-density polyethylene (HDPE) piping for nuclear applications, nondestructive evaluation is an important tool for evaluation of the integrity in fused joints. This paper will discuss the method of using ultrasonic phased array for inspecting butt-fusion (BF) joints in HDPE piping. The benefit of phased array is the ability to perform a volumetric inspection using multiple angles, which greatly increases the probability of detection of defects and allows the data to be analyzed using a representative two-dimensional image of the joint. It has been determined that successfully producing BF joints is highly dependent on environmental and mating-surface conditions. The primary defects of concern are lack-of-fusion, an area of the joint where there is no bond, cold fusion, an area of partial bond, and inclusion. Phased array has successfully demonstrated the ability of detecting and characterizing these defects using low frequency ultrasound. Factors addressed include joint location, wall thickness, material temperature, transducer wedge material, and manual versus automated data acquisition.
Frederick et al. (Wed,) studied this question.